Field notes
Lessons
each one cost a reprint or a redesign
Before designing round bought hardware
- Fold a hinge both ways by hand and write down where it stops. The Antrader torque hinge closes only with its countersunk sides together. Two layouts assumed the opposite.
- Measure anything that sticks out, on both faces: the hinge's stiffness screw, its raised block, its nut.
- Use a slot that is already proven for clip-in parts. Plain rectangular holes did not hold keystone jacks.
- Measure the user's actual spring / screw / jack rather than a catalogue size.
Checks to run on every change
- Overlap between every pair of neighbouring parts, through the full motion (hinge 0 to fully open, latch locked to slid open).
- Assembly path: can the part be slid or dropped into place, in the order things are built?
- Tool access: a straight screwdriver path above every screw head. A screw 10 mm in front of a post could not be driven.
checks.driverBlocked. - Screw length against what is behind it: a screw that ends "just short" of a part is a trap; put the hole where a longer screw would still miss.
- Each printed part is one solid (loose slivers have appeared between cut-outs).
- At least 2 mm of plastic round a screw slot or nut pocket; never a nut slot open on two sides.
Test prints
- Cut the test piece out of the real model, and include only the mechanism under test.
- Test before printing anything that takes more than a few hours.
- Do not mark a dependent part "ready" until the test it depends on has passed.
Slicing and printing (Bambu H3C and H2C)
- After every command-line slice, run
fix3mf.py, or the Bambu Studio app drops the supports on open. - Tall parts standing on a narrow face: 8 mm brim, 30 mm/s first layer.
- "It did not stick" on a plate that worked yesterday is usually the plate: wash it, handle by the edges.
- H2C, parts near the bed's full length: rotate and place by hand, no auto-arrange, prime tower off.
- Slicing two big halves on one plate saves no time and can raise path conflicts.
Working with the person printing
- Check whether a part is already printed or printing before changing it. If it is, keep the files that were used untouched, and make new or old parts fit what exists (slots, extra pockets) or put a variant in a separate folder.
- Say what has been tested on a printer and what has only passed the model's checks.